TECTYL Cavity Wax Amber

TECTYL Cavity Wax Amber

Tectyl Cavity Wax Amber is a wax based, solvent cutback, amber colored corrosion preventive. It has good water displacing and penetration properties, making it very suitable as a corrosion protective for the inside of cardoors and other hollow sections of cars and rolling equipment. It cures to an amber colored, waxy, semi-firm translucent film.

Surface preparation

The maximum performance of Tectyl Cavity Wax Amber can be achieved only when the metal surfaces to be protected are clean, dry and free of rust, oil and mill scale and a substrate temperature of 10-35 °C at the time of product application. 

Application

Tectyl Cavity Wax Amber gives a maximum performance when it is sprayed at an ambient and product temperature of 10-25 °C. Shake the can with Tectyl Cavity Wax Amber well before use and spray at approximately 30 cm from the surface. Tectyl Cavity Wax Amber is a fast-drying product this can cause “pin-holing” when the product is applied too thick at once. It is advised to spray one layer per pass, wait for 2 to 3 minutes and then spray another layer. Continue like this until the required film thickness has been obtained.  DO NOT FREEZE Tectyl Cavity Wax Amber.

Use a nozzle set for hard to reach areas!

The nozzle set is specially developed for hard to reach areas. The hose has a thickness of 4 mm.

Features TECTYL Cavity Wax Amber

• It will protect against corrosion and will displace water where needed
• With its strong penetration, it will protect the surface against corrosion, even in small seams and crevices