Colormatic 2K Epoxy Primer Filler in Aerosol
- 100 days returns & exchanges
- Customer reviews: 4.38/5 (723 reviews)
Universal 2K Epoxy Primer Aerosol
ColorMatic 2K epoxy primer filler is universally applicable to all metallic surfaces such as steel, galvanized steel and aluminium. It has excellent adhesion and corrosion protection properties and adheres well to fibreglass plastics. Once dry, overcoat with polyester products (spatula). It is solvent-based with an epoxy-resin basis. Free of isocyanate.
Quality and properties
- Excellent adhesion and corrosion protection for steel, galvanized steel and aluminium
- Adheres well to fibreglass
- Once dry, overcoat with polyester products (spatula)
- Long pot life
- Fast drying time
- Very good flow, wet-on-wet application possible
- Easy to sand - wet or dry
- Solvent resistant
- Good insulation against moisture
- Convenient 200 ml can to avoid leftover
- Simple, time-saving application
- Free of isocyanate
- Can be painted with all water-based paints and solvents, 1K and 2K topcoats
Physical and chemical data
- Basis of binder: EP
- Colour: grey
- Smell: solvent
- Efficiency: Depending on consistence and colour of the ground: 200 ml are sufficient for approx. 0,6 m²
- Substrate: bare metal cleaned and sanded, zinc coated metal cleaned and sanded, Aluminium cleaned and sanded, old paints cleaned and sanded, glass-fibre plastic cleanded and sanded
- Temperature resistance: to 90°C
- VOC-value: 108,6g
- Pot life: 5 days at least (20°C)
Using instructions
- Before use, carefully read and observe the warning texts on the label!
- Clean surface with ColorMatic silicone remover, then sand
- Primer: one coat about 15 - 20µ
- Filler: two coats, about 50-60µ
- 5 minutes drying time between coats
- Dry (20 ° C) 8 hours or 25 minutes (60 ° C) object temperature
- Wet-on-wet recoating possible after 20 minutes drying time
- The surface has to be sanded and recoated after 7 days
Mixing A components with hardener
- Shake can well until the audible noise of the mixing balls
- Remove the protection cap from the bottom of the can and pull the pin out fully with the help of the inserted ring. This will release the knife, which will penetrate the wall of the aluminium cartridge.
- The cartridge will then rotate 360 °, be completely open and release the hardener.
- Shake the can vigorously to mix the A components with the hardener in the proper, predetermined ratio.
- Shake can vigorously for 2 minutes
- Carry out spray test
- For professional use only Wear an appropriate respirator (we recommended type A2/P3)
| SKU | CMP231667 |
|---|---|
| Brand | MoTip |
| Packing | 1 piece |
| EAN | 4048500231667 |
| Content | 200 ml |
| Category | Alloy Wheel Repair |
How do you remove adhesive residues
Are there adhesive residues on your car from a sticker or car wrap? Removing adhesive residues from the car can be tricky without damaging the paint. To remove adhesive residues without scratching, it’s best to use a caramel wheel. This is a rubber grinding wheel specifically designed to remove adhesive residues without damaging the car paint
Should clear coat be applied over car paint?
Yes, you should use clear coat over 1K automotive paint to protect the color. When buying clear coat, you have options such as high-gloss, satin, and matte, as well as 1K and 2K. 2K clear coat is the original factory high-gloss finish and is the most commonly chosen varnish.
