Rust-Oleum EPOXYSHIELD ULTRA Floor Coating Quick Drying - 5 liter

Rust-Oleum EPOXYSHIELD ULTRA Floor Coating

Rust-Oleum EPOXYSHIELD ULTRA A quick-drying single pack water-based floor coating (epoxy-modified acrylic) for light to medium duty (normal foot traffic/limited vehicular traffic). Good resistance to diesel, motor oil, coolant fluid, various household chemicals and most types of tyre.

Quick drying floor coating

EPOXYSHIELD ULTRA is a 1-component quick drying floor coating. This fast-drying floor coating is touch dry after 2 hours and can be handled after 6 hours.

Recommended use

EpoxyShield 5200 ULTRA can be applied on concrete floors which are completely clean, dry and treated with EpoxyShield Sealer 5220. Do not apply to smooth and completely sealed concrete or concrete containing a curing compound. Such substrates will prevent a good adhesion. EpoxyShield 5200 ULTRA can also be applied on old good adhering coatings.

Surface preparation

Remove oil, grease and all other contaminants with EpoxyShield Cleaner/Degreaser 2901 in combination with high pressure cleaning. Allow new concrete to set for at least 30 days before applying a coating. Remove laitance, loose and damaged concrete by sandblasting or etching with RUSTOLEUM Surfa-Etch 108. Repair all holes and cracks with EpoxyShield concrete repair products. Always pre-treat absorbent, porous surfaces with EpoxyShield Sealer 5220. Roughen or blast well-sealed and smooth concrete and treat with Epoxyshield Sealer 5220 or apply a coat RUST-OLEUM 3333 Super Adhesive. Roughen still-intact floor coatings to ensure good adherence. Remove poorly adhering old coatings with wire brush and sandpaper. During application the surface must be clean and dry.

Rust-Oleum EPOXYSHIELD ULTRA Floor Coating in 3 colors

• Light grey: RAL 7035
• Steel grey: RAL 7001
• English red

How do I apply EPOXYSHIELD ULTRA Concrete Paint?

1. To ensure homogeneity, coating materials should be thoroughly stirred prior to use.
2. Temperature of air, substrate and coating material between 10 and 35°C. Relative humidity below 85%. The temperature of the surface must be at least 3°C above the dew point.
3. Product is ready for use, dilution is not necessary. Use a nylon paint roller (ca. 12 mm). In case of roller application, it can be necessary to apply 2 coats in order to achieve the prescribed film thickness.
4. Cleaning is required direct after application with water and soap.

Features Rust-Oleum EPOXYSHIELD ULTRA Floor Coating

• 1-component
• For light to medium traffic
• Easy to apply
• Touch dry after just 2 hours
• Satin matt finish
• Good resistance to car tyres and various chemicals