FINIXA tyre masking covers for the painting of rims - box 80 units

FINIXA masking covers for wheel rims

The FINIXA tyre masking covers have been specially developed to spray rims without the need to remove the tyre from the wheel. The masking film of these covers adheres to the paint so that the paint does not go through, so that the spray mist and paint drops do not touch the tyre. The masking covers are suitable for rims up to 22" in diameter and are packaged in sets of 4 in a box of 80 pieces in total.

How to fit this masking cover to a wheel?

Do you want to mount the masking cover on your car wheel? In a few simple steps, you can protect the tyres before spraying the rims. Follow the step-by-step plan below.

• Deflate the tyre.
• Make sure the wheel is clean and dry.
• Push the tyre off the edge of the rim.
• Mount the cover around the rim with the elastic band so that the whole tyre is covered.
• Start spraying the rim.
• After the paint has dried, remove the cover.
• Reinflate the tyre.

Tyre masking cover with elastic band

The masking cover has a hole in the middle lined with an elastic band. Thanks to the elastic band, the masking film fits precisely around the rim. The elastic band makes it possible to fit rims between 15 and 22 inches.

Features of the FINIXA tyre masking devices for rim painting

• Special masking cover for rim painting
• Suitable for rims between 15 and 22 inches
• With an elastic band in the middle
• Paint adhesion properties
• Temperature resistant up to 80°C
• Packed in sets of 4 covers
• A total of 20 sets of 4 covers in one box
• Maximum inner diameter: 58 cm