MOTIP RUST STOP 4 in 1 Peinture métal anti-rouille en aérosol 400ml

Quality and properties

• Solvent-based thick-film paint system
• Saves precious working time: no derusting and repeated lacquering
• Reduced cost, as no anti-rust products necessary
• Longlasting corrosion protection
• Quick-drying
• Very good flow
• High coverage and filling power
• High elasticity
• Shock-proof and impact resistant after drying
• Excellent adherence
• UV-resistant, non-yellowing
• Weather-resistant, waterproof
• Successfully tested in salt spray test over 500 hours
• Variable broad jet atomisation for horizontal or vertical spraying and a wide, proper spray pattern

Physical and chemical data

• Basis of the binder: Nitro-combi
• Colour: specific
• Smell: solvent
• Degree of gloss: measuring angle 60° after DIN 67530 Satin matt shades: 30 – 40 gloss units
• Efficiency: Depending on condition and colour of the ground, 400 ml are sufficient for approx. 1.5 – 2.0 m²
• Drying (at 20°C, 50% relative air humidity):
  Dust-dry: after 10 minutes
  Dry to touch: after approx. 20 minutes
  Cured/coatable: after approx. 30 minutes
  Can be re-coated: after approx. 12 hours
  The drying time depends of temperature of surroundings, air humidity and thickness of the applied layer.
• Temperature-resistance: up to 80°C
• Disposal: Put only empty cans into the recycling bin. Bring cans with remainders of paint to the special refuse disposal.
• Storage stability: 10 years if appropriate storage provided (=10°-25°C, relative air humidity max. 60%).
• Contents: aerosol cans with max. nominal volume of 400 ml

Using instructions

1. The most DUPLI-COLOR spray paints have a so-called no-spray ring or a tamper-proof cap.
2. This is to avoid unauthorized use.
3. Please see the corresponding advises on the cap or on the label.
4. Before use, carefully read and observe the warning texts on the label!
5. Remove loose rust from surface by use of a wire brush.
6. We recommend to sand smooth, blank metal surfaces slightly.
7. Surface has to be clean, dry and free of fat.
8. To improve the adherence, we recommend to prepare plastic parts with DUPLI-COLOR Plastic Primer.
9. Shake can for 3 minutes.
10. Test spray at an inconspicuous spot and test the compatibility.
11. Mask off areas not to be painted.
12. Spray several thin coats. Spray distance approx. 25 cm.
13. Do not spray on surfaces lacquered with synthetic paint!