Rust-Oleum EPOXYSHIELD MAXX Floor Coating
Rust-Oleum EPOXYSHIELD MAXX Floor Coating is a user friendly and easy to apply water-based epoxy garage floor coating with an ultimate adhesion and durability. The product has an excellent wear, impact and abrasion resistance like heavy foot and vehicle traffic. Resists chemicals and standing water.
Surface preparation
Repair any holes or cracks with EpoxyShield concrete repair products. If the floor is previously painted, remove any loose paint by sanding and scraping. Remove oil and grease using a scrub brush and EpoxyShield cleaner/degreaser. Rinse thoroughly with fresh water afterwards. Remove all water and allow to dry completely. Wipe your fingers over the clean, dry floor. If you see any dust or powder, repeat the rinsing until the floor is clean. Wipe your fingers over the clean, dry floor. If you see any dust or powder on your fingers, repeat the rinsing and scrubbing until the floor is clean.
Recommended use
Epoxyshield 5300 MAXX can be applied on concrete floors, which are completely clean and dry. It is not recommended to apply on smooth/dense concrete or concrete containing a curing compound, which will prevent a good adhesion. Epoxyshield 5300 MAXX can also be applied on old good adhering coatings. Epoxyshield 5300 MAXX Additives.
- EPOXYSHIELD Antislip Additive gives an excellent anti slip finish when mixed with EPOXYSHIELD 5300 MAXX.
- EPOXYSHIELD Decorative Chips are specially designed for use in combination with EPOXYSHIELD 5300 MAXX. The chips adhere permanently on the floor when they are sprinkled in the wet coating. They give a decorative finish and will also mask dirt and rugosity.
Rust-Oleum EPOXYSHIELD MAXX Floor Coating in 4 colors
- Light grey: RAL 7035
- Steel grey: RAL 7001
- Light ivory: RAL 1015
- English red
Directions for use
Pour the contents of A into B and stir thoroughly for at least 3 minutes. Allow mixed product to stand (see table) before rolling the coating on to the surface. Do not leave container indirect sunlight. Mix again before applying. The product must be used within 1 to 2 hours of initial mixing (pot life, see table). This time decreases at higher temperatures. Do not mix Paint Chips with Epoxyshield 5300 MAXX.
Techical data and drying times
- Density: 1,27
- Gloss Level: Satin
- Solids content in volume: 63.6%
- Mixing Ratio: Base : Activator = 3 : 1 (volume)
- Dry to handle: 16 hours (suitable for light foot traffic)
- Dry to recoat: 24 hours (suitable for normal foot traffic and heavy items)
- Fully cured: 7 days (suitable for vehicle traffic)
- Pot life: 2 hours (15 degrees) 1,5 hours (21 degrees), 1 hours (26 degrees)
Features Rust-Oleum EPOXYSHIELD MAXX Floor Coating
- Water based
- For medium to heavy traffic
- Easy to apply, no primer required
- Long-lasting gloss finish (Non-skid or decorative finish optional)
- Highly resistant against solvents, chemicals and car tyres
