MOTIP DPF Cleaner in 500ml Aerosol

Tool to loosen and remove ash deposits in diesel-particle filter systems, without disassembly. Applications Desel-particle filter systems

Product characteristics

• Fast-acting
• Free from solvents
• Non-corrosive
• Non-flammable
• Physical and

Chemical Characteristics

• Contents : 500 ml
• Basis : Solution of specific tensides
• Propellant : Inert propellant
• VOC-content : 0% w/w
• Relative density at 20°C : 0,99 g/ml
• Vapour pressure at 20°C : 7 -to 9 bar

Usage

1. Before use, carefully read the instructions on the packaging and act accordingly.
2. For professional use only The aerosol should have room temperature.
3. Best processing temperature 5 to 30°C.
4. Before use, shake the aerosol.
5. Before use, allow the engine to cool down (maximum 50°C).
6. Observe the instructions of the car manufacturer.
7. Disassemble temperature or pressure sensor from the filter.
8. Insert the special tube into the opening.
9. Empty the can in the following intervals: spray 3 - 5 times; allow to soak for 5 seconds.
10. Install temperature or pressure sensor.
11. Start the engine and allow to run stationary for at least 15 minutes to evaporate most of the fluid.
12. Make a test-drive of 30 minutes.
13. This may cause the formation of steam.