5in1 Rinçage du système d'huile
Clean the engine and oil of your car
5in1 Oil System Flush removes harmful deposits. Engine oils can form acids as a result of the combustion process and oxidation. Even after draining the engine oil and changing the filter, residual acid contamination can remain in the crankcase in sludge form which in turn can corrupt the protection properties of your new oil. Adding 5in1 Engine Flush to your used oil before draining helps neutralise acid, dissolves varnish and removes sludge that ordinary draining would leave behind whilst providing friction proofing during treatment.
How to use?
Instructions for use: Bring engine to operating temperature then switch engine off. Add contents to used engine oil, restart engine and run at idle speed for 5 mins. Note: Do not drive the vehicle or rev the engine until used oil has been replaced with fresh oil. While engine is still warm, drain crankcase. Change oil filter and oil. Dispose of waste oil in accordance with local authority regulations.
Properties
- Engine Oils can form acids...
- Neutralises acid residue
- Removes harmful deposits
- Improves oil circulation
- Cleans engine in 5 minutes
- Concentrated formulation for petrol and diesel engines
5in1 Oil System Flush technical data:
- Preventing -Liquid/
- Color -yellow
- Smell -hydrocarbon.
- Solubility -Not miscible with water
- boiling point and boiling -200-250 ° c. @ 760 mm Hg
- Relative density -0.80 @ 15 ° C
- Vapour Density -> 1 (air = 1)
- Vapour Pressure -< 10 mbar @ 37.8 ° C
- Viscosity -1.5 cSt 40 ° C
- Flash Point -61-93.4 ° C
- Vp class- NVT
- Auto-Ignition Temperature -(° C) 225 ° C
- Flammability -Layer (Percent) 0,5