COLAD 2K Plastic Adhesive - Super Fast 30 seconds
COLAD 2K-PU Plastic Adhesive - 30 seconds
COLAD 30 Seconds Super Fast curing. Powerful 2 component (2K-PU) plastic adhesive. For all-purpose structural bonding of plastic parts. Resistant to exposure to elevated temperature, moisture, fuel, many solvents and chemicals. Specially designed for small, quick, durable bonding and repair jobs. Colour Black. Cartridge of 50 ml. Per piece, with 2 mixing tips.
What can I use the 2K plastic adhesive for?
This 2-component PU adhesive can be used with quick and small plastic repairs. Think of the bonding of plastic moldings, bumper and headlight fastening points, emblems and other fast cosmetic and structural plastic repairs. Finally, this polyurethane adhesive is also used for fixing and holding plastic car parts in place.
- Small & Quick plastic repairs
- Fixing and holding plastic car parts in place
- Emblems, bumper tabs and moldings
Moldings, bumper tabs and emblems
Benefits COLAD 30 seconds 2K-PU Adhesive glue
- Sandable in 5 minutes
- Excellent adhesion on almost all plastics
- No smell. Fast cure.
- Excellent gap filling properties
Features & Technical specifications COLAD 90672258 Super Fast 2K-PU Adhesive
- Open time 30 seconds (at 23 degrees Celsius)
- Handling time (at 23 degrees Celsius)
- Sanding time 5 minutes (at 23 degrees Celsius)
- Paint time 5 minutes (at 23 degrees Celsius)
Substrate Preparation and processing
- The surface has to be clean, and free of dust, oil and grease.
- Attach the Mixer Tip on top.
- Press out some product (± 25 – 50 mm) To make sure that the product is properly mixed.
- Pull the trigger of the 2K Manual Gun at a constant force for an even layer of adhesive.
- Make sure that the top of the Mixer Tip is always in the product, this prevents air from enclosing in the adhesive. Which will form air bubbles when applied.
- When cured (read technical information) sand and refinish when needed.
- After finishing leave the mixer tip in place.
- When using again, remove the mixer tip. Carefully clean the cartridge nozzle. (The products in the two chambers must be cleanly separated.) Attach a new mixer tip and start a new job.
Example repair of a hole in a plastic part
- Clean the surface with the COLAD Plastic Cleaner
- Drill holes around the damaged area for good adhesion
- Model and shed where necessary
- Apply the COLAD Plastic Primer
- Cut the COLAD Reinforcement Film
- Apply the glue to the Reinforcement Foil
- Place the Reinforcement Foil and the glue on the back of the damaged area
- Apply form foil to the front of the area covered
- Press gently, spread out adhesive evenly