COLAD 2K Plastic Adhesive - Fast 90 seconds
COLAD 2K-PU Plastic Adhesive - 90 seconds
COLAD 2K-PU Plastic Adhesive.1.5 minutes fast curing. Powerful 2-component (2K-PU) plastic adhesive. For all-purpose structural bonding of plastic parts. Resistant to exposure to elevated temperature, moisture, fuel, many solvents and chemicals. Repair a variety of plastic parts. For small - medium sized repairs with durable bonding and repair jobs. Colour Black. Cartridge of 50 ml. Per piece, with 2 mixing tips.
What can I use the 2K plastic adhesive for?
This 2-component PU adhesive can be used for small to medium-sized repairs. Think of repairing various plastic parts such as repairs of bumpers, panel clamps, radiator grilles, headlight brackets etc.
- Small to medium-sized repairs
- Bumpers, panel clamps, radiator grilles, headlight brackets
- Repair various plastic parts
Repair car bumpers and headlight brackets
Benefits COLAD 90 seconds 2K-PU Plastic Adhesive
- Sandable in 10 minutes
- Excellent adhesion on almost all plastics
- No smell. Fast cure.
- Excellent gap filling properties
Features & Technical specifications COLAD 90672259 Fast 2K-PU glue
- Open time 90 seconds (at 23 degrees Celsius)
- Handling time in 10 minutes (at 23 degrees Celsius)
- Sanding time 10 minutes (at 23 degrees Celsius)
- Paint time 10 minutes (at 23 degrees Celsius)
Substrate Preparation and Processing
- The surface has to be clean, and free of dust, oil and grease.
- Attach the Mixer Tip on top.
- Press out some product (± 25 – 50 mm) To make sure that the product is properly mixed.
- Pull the trigger of the 2K Manual Gun at a constant force for an even layer of adhesive.
- Make sure that the top of the Mixer Tip is always in the product, this prevents air from enclosing in the adhesive. Which will form air bubbles when applied.
- When cured (read technical information) sand and refinish when needed.
- After finishing leave the mixer tip in place.
- When using again, remove the mixer tip. Carefully clean the cartridge nozzle. (The products in the two chambers must be cleanly separated.) Attach a new mixer tip and start a new job.
Example repair of a hole in a plastic part
- Clean the surface with the COLAD Plastic Cleaner
- Drill holes around the damaged area for good adhesion
- Model and shed where necessary
- Apply the COLAD Plastic Primer
- Cut the COLAD Reinforcement Film
- Apply the glue to the Reinforcement Foil
- Place the Reinforcement Foil and the glue on the back of the damaged area
- Apply form foil to the front of the area covered
- Press gently, spread out adhesive evenly